I have decided to buy this cubby box for future trip due to the quality product i am use to from MSS
Main box:
Height: 250mm
Width: 250mm
Depth: 420mm at the bottom, 310mm at the top (sloping front)
Stereo: 75mm x 200mm
Cup holder: 80mm x 200mm
Cushion: 70mm x 250mm x 250mm
The whole thing bolts to the centre access panel made of 4 seperate spacers bolt together and the floor, there 4 bolts that then will fix the cubby via 4 openings to the threaded spacers.
nut thread underneath on the spacers and bolts openings from within the cubby box. The height of the spacers allows the cup holder to just clear the lip at the front of the seat box. The lid is slightly oversized to overlap the front and sides of the box.
The rear has 2 circle openings that you can use for 2 USB /12V sockets ( the holes are only covered in a plastic cover.
View of the middle section, you can see here hole C and hole D, on a defender Td5 model 2005 could not find a purpose for hole E and F that you can see on the bracket itself on the right.
Hole C below front view
Hole C back view where the panel will be bolted using the same bolt and opening
Hole A + Hole B side opening for which we will use 2 bolts washers + nyloc to mount the frame together
The Blue highlight is Nusert G is the underfloor mounting bracket which i did not fit because i was happy with the 3 point fix that i already have. i beleive this part implies drilling as the position of this bracket will be in the middle without any support from any existing bolts.
Yellow hightlight are the Nusert F 4 positions on which the cubby will be fixed.
Yellow hightlight again are the Nusert F
Nusert F final position over the lip and closer to the bulkhead
Hole D which is already existing in the landy , the panel opening is excatly located on top of it
You can see clearly that the frame is fixed with the bolt in the back and the 2 bolts in the front
Hole C – 4 bolts in the bottom to holdit to the spacers frame below
CHE OVERLAND Land Rover Defender 90 Td5 
Leave a comment